ts_127007v110800p

Recommendations

Info

3GPP TS 27.007 version 11.8.0 Release 11 205 ETSI TS 127 007 V11.8.0 (2013-10) +CGTFT= Command Possible Response(s) +CGTFT: ,(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s) [+CGTFT: ,(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s),(list of supported s) [...]] Description This command allows the TE to specify a Packet Filter - PF for a Traffic Flow Template - TFT that is used in the GGSN in UMTS/GPRS and Packet GW in EPS for routing of packets onto different QoS flows towards the TE. The concept is further described in the 3GPP TS 23.060 [47]. A TFT consists of from one and up to 16 Packet Filters, each identified by a unique . A Packet Filter also has an that is unique within all TFTs associated with all PDP contexts that are associated with the same PDP address. The set command specifies a Packet Filter that is to be added to the TFT stored in the MT and used for the context identified by the (local) context identification parameter, . The specified TFT will be stored in the GGSN in UMTS/GPRS and Packet GW in EPS only at activation or MS-initiated modification of the related context. Since this is the same parameter that is used in the +CGDCONT and +CGDSCONT commands, the +CGTFT command is effectively an extension to these commands. The Packet Filters consist of a number of parameters, each of which may be set to a separate value. A special form of the set command, +CGTFT= causes all of the Packet Filters in the TFT for context number to become undefined. At any time there may exist only one PDP context with no associated TFT amongst all PDP contexts associated to one PDP address. At an attempt to delete a TFT, which would violate this rule, an ERROR or +CME ERROR response is returned. Extended error responses are enabled by the +CMEE command. Refer subclause 9.2 for possible values. The read command returns the current settings for all Packet Filters for each defined context. The test command returns values supported as a compound value. If the MT supports several PDP types, the parameter value ranges for each PDP type are returned on a separate line. TFTs shall be used for PDP-type IP and PPP only. For ETSI
3GPP TS 27.007 version 11.8.0 Release 11 206 ETSI TS 127 007 V11.8.0 (2013-10) PDP-type PPP a TFT is applicable only when IP traffic is carried over PPP. If PPP carries header-compressed IP packets, then a TFT cannot be used. Defined values : integer type. Specifies a particular PDP context definition (see the +CGDCONT and +CGDSCONT commands). : string type. Specifies the type of packet data protocol (see the +CGDCONT command). For the following parameters, see also 3GPP TS 23.060 [47]: : integer type. Value range is from 1 to 16. : integer type. The value range is from 0 to 255. : string type. The string is given as dot-separated numeric (0-255) parameters on the form: "a1.a2.a3.a4.m1.m2.m3.m4" for IPv4 or "a1.a2.a3.a4.a5.a6.a7.a8.a9.a10.a11.a12.a13.a14.a15.a16.m1.m2.m3.m4.m5.m6.m7.m8.m9.m10.m11.m12.m13. m14.m15.m16", for IPv6. When +CGPIAF is supported, its settings can influence the format of this parameter returned with the read form of +CGTFT. : integer type. Value range is from 0 to 255. : string type. The string is given as dot-separated numeric (0-65535) parameters on the form "f.t". : string type. The string is given as dot-separated numeric (0-65535) parameters on the form "f.t". : numeric value in hexadecimal format. The value range is from 00000000 to FFFFFFFF. : string type. The string is given as dot-separated numeric (0-255) parameters on the form "t.m". : numeric value in hexadecimal format. The value range is from 00000 to FFFFF. Valid for IPv6 only. : integer type. Specifies the transmission direction in which the packet filter shall be applied. 0 Pre-Release 7 TFT filter (see 3GPP TS 24.008 [8], table 10.5.162) 1 Uplink 2 Downlink 3 Birectional (Up & Downlink) Some of the above listed attributes may coexist in a Packet Filter while others mutually exclude each other, the possible combinations are shown in 3GPP TS 23.060 [47]. Implementation Optional. 10.1.4 Quality of service profile (requested) +CGQREQ Table 114: +CGQREQ parameter command syntax Command +CGQREQ=[[,[,[, Possible Response(s) ETSI
Page 1 and 2:
ETSI TS 127 007 V11.8.0 (2013-10) T
Page 3 and 4:
3GPP TS 27.007 version 11.8.0 Relea
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156: 3GPP TS 27.007 version 11.8.0 Relea
Page 205: 3GPP TS 27.007 version 11.8.0 Relea
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

ts_127007v110800p

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?