07.01.2015 Views

ts_127007v110800p

ts_127007v110800p

ts_127007v110800p

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

3GPP TS 27.007 version 11.8.0 Release 11<br />

32<br />

ETSI TS 127 007 V11.8.0 (2013-10)<br />

If the Call Mode is set to VOIP_ONLY, then the ATD command will make a call in VoIP mode.<br />

If the Call Mode is set to CS_PREFERRED, then the ATD command gives preference for CS based voice<br />

call.<br />

If the Call Mode is set to VOIP_PREFERRED, then the ATD command gives preference for VoIP based<br />

voice call<br />

NOTE 2: The preferences are not applicable for the emergency call.<br />

NOTE 3: The preferences are not applicable if operator has set preferences for UE originated calls/sessions,<br />

3GPP TS 24.216 [75] subclause 5.6.<br />

Read command returns the current value of .<br />

Test command returns the values supported by the UE.<br />

Defined values<br />

: integer type<br />

0 CS_ONLY<br />

1 VOIP_ONLY<br />

2 CS_PREFERRED<br />

3 VOIP_PREFERRED<br />

Implementation<br />

Optional.<br />

6.5 Hangup call +CHUP<br />

Table 13a: +CHUP action command syntax<br />

Command<br />

+CHUP<br />

+CHUP=<br />

Possible response(s)<br />

Description<br />

Execution command causes the TA to hangup the current GSM/UMTS call of the MT.<br />

NOTE:<br />

The purpose of this command is not to replace the ITU-T Recommendation V.250 [14] command H, but<br />

to give an assured procedure to terminate an alternating mode call. Refer next subclause.<br />

Implementation<br />

Mandatory when alternating mode calls implemented in the TA.<br />

6.6 Alternating mode call control method<br />

This subclause describes the procedure to handle alternating mode calls with AT commands. Procedures are mandatory<br />

when alternating mode calls are implemented in the TA.<br />

NOTE 1: ATH and drop DTR will not necessarily cause a hangup from voice mode. If the +CVHU is implemented<br />

the behaviour shall be controlled by i<strong>ts</strong> setting.<br />

ETSI

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!