ts_127007v110800p

3GPP TS 27.007 version 11.8.0 Release 11
245
ETSI TS 127 007 V11.8.0 (2013-10)
When in E-UTRAN, if further conditions defined in 3GPP TS 36.331 [86] are met, this can cause transmission of a
UEAssistanceInformation message with powerPrefIndication set to "lowPowerConsumption" to the network.
NOTE:
See subclause 10.1.38 for a command applicable to an MT using E-UTRAN, where the MT has a
preference for a configuration that is not optimized for power saving.
This command may be used in both normal and modem compatibility modes.
Implementation
Optional.
10.1.34 UE's usage setting for EPS +CEUS
Table 10.1.34-1: +CEUS parameter command syntax
Command
+CEUS=[]
+CEUS
+CEUS=
+CEUS:
Possible Response(s)
+CEUS: (list of supported s)
Description
The set command is used to set the MT to operate according to the specified UE's usage setting for EPS, see
3GPP TS 24.301 [83].
The read command returns the usage setting set by the TE.
The test command is used for requesting information on the supported MT setting(s).
Defined Values
: integer type; indicates the usage setting of the UE. The default value is manufacturer specific.
0 voice centric
1 data centric
NOTE: The definition for usage settings of the UE can be found in 3GPP TS 24.301 [83].
Implementation
Optional.
10.1.35 UE's Voice Domain Preference E-UTRAN +CEVDP
Table 10.1.35-1: +CEVDP parameter command syntax
Command
+CEVDP=[]
+CEVDP
+CEVDP=
+CEVDP:
Possible Response(s)
+CEVDP: (list of supported s)
Description
The set command is used to set the MT to operate according to the specified voice domain preference for E-UTRAN.
The read command returns the setting, independent of the current serving cell capability and independent of the current
serving cell's access technology.
ETSI