ts_127007v110800p

Recommendations

Info

3GPP TS 27.007 version 11.8.0 Release 11 173 ETSI TS 127 007 V11.8.0 (2013-10) 7 CS to PS SRVCC handover cancelled ("Handover Failure" sent). 8 CS to PS SRVCC handover, general non-specific failure. 9 CS to PS SRVCC handover successful ("Handover Complete" sent). NOTE 1: Value 3 and 8, general non-specific failure, might be used e.g. in the case of handover cancellation as specified in 3GPP TS 24.301 [83] subclause 6.6.2. NOTE 2: The naming of SRVCC and vSRVCC handover information values is different from the naming of corresponding NAS session management notifications. Implementation Optional. 8.65 Remaining PIN retries +CPINR Table 8.65-1: +CPINR action command syntax Command +CPINR[=] +CPINR= Possible response(s) +CME ERROR: Description Execution command cause the MT to return the number of remaining PIN retries for the MT passwords with intermediate result code +CPINR: ,[,] for standard PINs and +CPINRE: ,[,] for manufacturer specific PINs. One line with one intermediate result code is returned for every or selected by . When execution command is issued without the optional parameter , intermediate result codes are returned for all s and s. In the intermediate result codes, the parameter is an optional (manufacturer specific) parameter, per and . Defined values : integer type. Number of remaining retries per PIN. : integer type. Number of default/initial retries per PIN. : Type of PIN. All values listed under the description of the AT+CPIN command, parameter, except 'READY'. : Extended, manufacturer specific codes. : String type. Same values as for the and parameters. These values are strings and shall be indicated within double quotes. It is optional to support wildcard match by '*', meaning match any (sub-)string. Example: AT+CPINR="SIM*" will return the lines: +CPINR: SIM PIN,, +CPINR: SIM PUK,, +CPINR: SIM PIN2,, +CPINR: SIM PUK2,, Example: AT+CPINR="*SIM*" will additionally return the lines: ETSI
3GPP TS 27.007 version 11.8.0 Release 11 174 ETSI TS 127 007 V11.8.0 (2013-10) +CPINR: PH-SIM PIN,, +CPINR: PH-FSIM PIN,, +CPINR: PH-FSIM PUK,, Implementation Optional. 8.66 Set card slot +CSUS Table 8.66-1: +CSUS parameter command syntax Command +CSUS=[] +CSUS +CSUS= Possible response(s) +CME ERROR: +CSUS: +CSUS: (number of supported s) Description When a MT is equipped with multiple card slots, the set command directs the MT to select the SIM/UICC card installed in the indicated card slot in all future actions that require the use of SIM/UICC. If this command is issued when a SIM/UICC is active, +CME ERROR is returned. Refer to subclause 9.2 for values. Read command returns the currently selected card slot. Test command returns the number of card slots in the MT. The numbering of card slots is implementation dependent. Defined values : integer type. 0 the SIM/UICC card installed in card slot 0 1 the SIM/UICC card installed in card slot 1 2 the SIM/UICC card installed in card slot 2 3 the SIM/UICC card installed in card slot 3 Implementation Optional. 8.67 Emergency numbers +CEN Table 8.67-1: +CEN parameter command syntax Command +CEN=[] +CEN +CEN= Possible response(s) +CEN1: [,,] [+CEN2: , [+CEN2: , [...]]] +CEN: (list of supported s) ETSI
Page 1 and 2:
ETSI TS 127 007 V11.8.0 (2013-10) T
Page 3 and 4:
3GPP TS 27.007 version 11.8.0 Relea
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124: 3GPP TS 27.007 version 11.8.0 Relea
Page 173: 3GPP TS 27.007 version 11.8.0 Relea
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

ts_127007v110800p

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?