ts_127007v110800p

Recommendations

Info

3GPP TS 27.007 version 11.8.0 Release 11 53 ETSI TS 127 007 V11.8.0 (2013-10) 0 asynchronous modem 1 synchronous modem 2 PAD Access (asynchronous) 3 Packet Access (synchronous) 4 voice 5 fax all other values below 128 are reserved by the present document : integer type (information transfer capability) 0 3,1 kHz 1 UDI Implementation Optional. 7.2 Network registration +CREG Table 35: +CREG parameter command syntax Command +CREG=[] +CREG +CREG= Possible response(s) +CME ERROR: +CREG: ,[,[],[],[] [,,]] +CREG: (list of supported s) Description Set command controls the presentation of an unsolicited result code +CREG: when =1 and there is a change in the MT"s circuit mode network registration status in GERAN/UTRAN/E-UTRAN, or unsolicited result code +CREG: [,[],[],[]] when =2 and there is a change of the network cell in GERAN/UTRAN/E-UTRAN. The parameters , and are sent only if available. The value =3 further extends the unsolicited result code with [,,], when available, when the value of changes. NOTE 1: If the MT also supports GPRS services and/or EPS services, the +CGREG command and +CGREG: result codes and/or the +CEREG command and +CEREG: result codes apply to the registration status and location information for those services. Read command returns the status of result code presentation and an integer which shows whether the network has currently indicated the registration of the MT. Location information elements , and , if available, are returned only when =2 and MT is registered in the network. The parameters [,,], if available, are returned when =3. Refer subclause 9.2 for possible values. Test command returns values supported as a compound value. Defined values : integer type 0 disable network registration unsolicited result code 1 enable network registration unsolicited result code +CREG: ETSI
3GPP TS 27.007 version 11.8.0 Release 11 54 ETSI TS 127 007 V11.8.0 (2013-10) 2 enable network registration and location information unsolicited result code +CREG: [,[],[],[]] 3 enable network registration, location information and cause value information unsolicited result code +CREG: [,[],[],[][,,]] : integer type; circuit mode registration status 0 not registered, MT is not currently searching a new operator to register to 1 registered, home network 2 not registered, but MT is currently searching a new operator to register to 3 registration denied 4 unknown (e.g. out of GERAN/UTRAN/E-UTRAN coverage) 5 registered, roaming 6 registered for "SMS only", home network (applicable only when indicates E-UTRAN) 7 registered for "SMS only", roaming (applicable only when indicates E-UTRAN) 8 attached for emergency bearer services only (see NOTE 2) (not applicable) 9 registered for "CSFB not preferred", home network (applicable only when indicates E-UTRAN) 10 registered for "CSFB not preferred", roaming (applicable only when indicates E-UTRAN) NOTE 2: 3GPP TS 24.008 [8] and 3GPP TS 24.301 [83] specify the condition when the MS is considered as attached for emergency bearer services. : string type; two byte location area code (when indicates value 0 to 6), or tracking area code (when indicates value 7). In hexadecimal format (e.g. "00C3" equals 195 in decimal). : string type; four byte GERAN/UTRAN/E-UTRAN cell ID in hexadecimal format. : integer type; access technology of the serving cell 0 GSM 1 GSM Compact 2 UTRAN 3 GSM w/EGPRS (see NOTE 3) 4 UTRAN w/HSDPA (see NOTE 4) 5 UTRAN w/HSUPA (see NOTE 4) 6 UTRAN w/HSDPA and HSUPA (see NOTE 4) 7 E-UTRAN NOTE 3: 3GPP TS 44.060 [71] specifies the System Information messages which give the information about whether the serving cell supports EGPRS. NOTE 4: 3GPP TS 25.331 [74] specifies the System Information blocks which give the information about whether the serving cell supports HSDPA or HSUPA. : integer type; indicates the type of . 0 Indicates that contains an MM cause value, see 3GPP TS 24.008 [8] Annex G. 1 Indicates that contains a manufacturer specific cause. ETSI
Page 1 and 2:
ETSI TS 127 007 V11.8.0 (2013-10) T
Page 3 and 4: 3GPP TS 27.007 version 11.8.0 Relea
Page 53: 3GPP TS 27.007 version 11.8.0 Relea
Page 105 and 106:
3GPP TS 27.007 version 11.8.0 Relea
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
show all

ts_127007v110800p

Create successful ePaper yourself

Delete template?

Save as template?