Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Basic System Information<br />
<strong>Series</strong> <strong>04</strong> <strong>Ku</strong>-<strong>Band</strong> <strong>TVRO</strong> <strong>Antenna</strong><br />
standard outputted from the satellite receiver. In some areas the satellite receiver may pass several<br />
different video formats, depending on the program being watched. You may need a video<br />
standards converter for each television/monitor which is not capable of displaying the signal being<br />
received (NTSC, PAL or SECAM video input) “Multi-Standard” televisions/monitors are able to<br />
automatically display any of the major video standard inputs. Consult your Television/Monitor<br />
manual for specifics.<br />
3.3.6. Matrix Switch<br />
The Matrix Switch routes the satellite signal from one of the IF cables to one of your receivers. As<br />
you change channels on the satellite receiver, it uses the voltage, and/or tone, to select the correct<br />
signal input for the channel you have selected.<br />
Each output of the matrix switch is controlled by voltage, and/or tone, from the satellite receiver<br />
connected to that output connector. Voltage level on the coax selects which polarity, Tone selects<br />
which band of the input signals gets routed to that output connector, therefore, to that receiver.<br />
Each output of the matrix switch operates independently of the others, therefore, allows the<br />
satellite receivers to operate independently also.<br />
The matrix switch is normally installed with the Below Decks Equipment. The antenna IF coax<br />
cables are connected to its LNB inputs and a coax cable (RG-6 OR greater) is connected from one<br />
of its outputs to each satellite receiver. One of these outputs must be connected the tracking<br />
receiver in the ACU.<br />
Sea Tel recommends that an ACTIVE Matrix be used in all installations. Matrix switches with 4, 8,<br />
12 and 16 outputs are available.<br />
3-8