Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Troubleshooting and Maintenance<br />
<strong>Series</strong> <strong>04</strong> <strong>Ku</strong>-<strong>Band</strong> <strong>TVRO</strong> <strong>Antenna</strong><br />
8. Using a 7/64” Allen Wrench,<br />
remove 3 screws (4 if Polang<br />
Harness Shield was grounded at<br />
Motor Termination PCB).<br />
9. Carefully remove Polang<br />
Assembly from reflector. Do<br />
Not Pry off the retaining ring<br />
epoxied to reflector. (40<strong>04</strong> and<br />
50<strong>04</strong> dishes are as shown, 30<strong>04</strong><br />
systems do not have an epoxy<br />
ring installed).<br />
10. From the back side of feed<br />
assembly, Use a 5/32” Allen<br />
Wrench to remove the screws<br />
securing 24V Polang Motor to<br />
bracket assembly. Save all<br />
hardware for future use<br />
11. Remove Polang Motor and set<br />
aside.<br />
7-42