Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Troubleshooting and Maintenance<br />
<strong>Series</strong> <strong>04</strong> <strong>Ku</strong>-<strong>Band</strong> <strong>TVRO</strong> <strong>Antenna</strong><br />
2. Using a 5/32” Allen Wrench,<br />
remove the four Allen Head<br />
screws attaching elevation<br />
motor bracket to CL beam and<br />
remove motor assembly.<br />
3. Observe cable orientation in<br />
reference to bracket and then<br />
remove Motor from bracket.<br />
4. Using a 9/64” Allen Wrench,<br />
remove the four Allen Head<br />
screws attaching motor to<br />
bracket. Remove save hardware<br />
for future use.<br />
5. Install replacement motor, and<br />
cable, onto the bracket (with<br />
cable in the same orientation<br />
observed in step 3) using the<br />
hardware removed in step 3. Do<br />
not tighten at this time.<br />
6. Re-install bracket onto CL beam<br />
using two of the Allen head<br />
screws removed in step 2, do<br />
not fully tighten.<br />
7. Place belt around elevation<br />
driven sprocket and then<br />
elevation motor sprocket.<br />
8. Install the other two allen head<br />
screws and Secure motor<br />
bracket onto CL Beam using<br />
Loctite 222 on all four screws.<br />
7-30