Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Series</strong> <strong>04</strong> <strong>Ku</strong>-<strong>Band</strong> <strong>TVRO</strong> <strong>Antenna</strong><br />
Troubleshooting and Maintenance<br />
10. Rotate <strong>Antenna</strong> from CCW stop<br />
to CW stop while observing belt.<br />
Check to see the belt does not<br />
rub against motor mounting<br />
hardware and that the belt<br />
remains level with both<br />
sprockets.<br />
7.4.8. Replacing Elevation Drive Motor<br />
The following procedure for replacing Elevation belt with the factory installed spare belt on CL<br />
beam.<br />
Tools Required:<br />
• 9/64” Allen Head Wrench<br />
• 5/32” Allen Head Wrench<br />
• Snips / Flush Cutters<br />
• 2 mm Flat Blade Screwdriver<br />
• Loctite 222 or equiv.<br />
NOTE: Unless otherwise indicated, all nuts and bolts should be<br />
assembled with Loctite 222 or its equivalent.<br />
1. Using 2mm Flat Blade<br />
Screwdriver, loosen two<br />
retaining screws on EL Motor<br />
harness and remove it from AZ<br />
post.<br />
7-29