Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Troubleshooting and Maintenance<br />
<strong>Series</strong> <strong>04</strong> <strong>Ku</strong>-<strong>Band</strong> <strong>TVRO</strong> <strong>Antenna</strong><br />
10. Plug the level cage cable back<br />
into the D-Sub connector and<br />
tighten retaining screws.<br />
11. Place the belt onto the level<br />
cage pulley.<br />
12. Place the belt onto Stepper<br />
Motor sprocket.<br />
13. Tension belt by sliding Motor<br />
sprocket assembly by hand<br />
away from level cage and<br />
tighten the four 4/40 screws<br />
loosened in step 2 with Loctite<br />
222.<br />
14. Rotate Level Cage by hand to<br />
the CCW and CW stop and<br />
check belt tension. Tension on<br />
belt should just enough to<br />
engage drive to level cage.<br />
(approx. 3/16” play when<br />
pinched) If belt tension is<br />
tighter at the CCW stop than<br />
the CW stop or vice versa than<br />
readjust for proper tension with<br />
the level cage oriented where<br />
belt tension was greatest.<br />
15. Check and/or adjust <strong>Antenna</strong><br />
balance.<br />
7.4.4. To Adjust Tilt:<br />
Select the REMOTE TILT window on the ACU and;<br />
1. Set a bubble (or bulls-eye) level on top of the Level Cage assembly. NOTE: If the level cage<br />
is not within 4 degrees of level fore/aft or left/right, replace the Level Cage assembly.<br />
2. If the level cage is within 4 degrees in BOTH For/Aft and Left/Right, use the UP/DOWN<br />
arrow keys to adjust LV (fore/aft) until the level cage is level in this axis.<br />
3. Use the LEFT/RIGHT arrow keys to adjust CL (left/right) until the level cage is level in this<br />
axis.<br />
4. Once the level cage is level in both axes, wait for 30 seconds then press the ENTER key.<br />
7-20