Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
Series 04 Ku-Band TVRO Antenna
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Series</strong> <strong>04</strong> <strong>Ku</strong>-<strong>Band</strong> <strong>TVRO</strong> <strong>Antenna</strong><br />
Troubleshooting and Maintenance<br />
5. Loosen four Allen Head Screws<br />
securing CL Motor Bracket to AZ<br />
Post. Complete removal of<br />
hardware is not required.<br />
6. Install belt around CL Motor<br />
Sprocket.<br />
7. Tension belt by pulling the<br />
motor bracket down towards the<br />
antenna base and tighten the<br />
four screws with Loctite 222.<br />
8. Rotate CL beam from CCW stop<br />
to CW stop (Left to right as<br />
viewed from behind reflector)<br />
and verify CL belt does not rub<br />
against AZ Post and runs inline<br />
with both sprockets. Incorrect<br />
belt travel is most frequently<br />
caused by incorrect sprocket<br />
placement on elevation motor<br />
shaft.<br />
7.4.11. Replacing CL Drive Belt<br />
Tools Required:<br />
• 9/64” Allen Head Wrench<br />
• 5/32” Allen Head Wrench<br />
• Snips / Flush Cutters<br />
• 2 mm Flat Blade Screwdriver<br />
• Loctite 222 or equiv.<br />
7-35