User's Manual - Pixord

More documents

Recommendations

Info

1.4 NDC ID Address Setting Refer ChartUp to 64 NDC can be serial linking in one system. Therefore each dome is addressing by ID switch located at the baseof the NDC. Below is the address setting for camera 1~64:11
2 Installation2.1 Installation PreviewThere are 3 mains steps required to perform a successful installation:• Hardware installation• Software installation• Network configurationHardware installation consists of connecting cables to the NDC including network, video, and power cables.Software installation consists of the installation of software that is necessary to properly view the video from the NDCor to configure the NDC itself. The software includes:• IP Installer -- a utility for locating devices and configuring network settings on a LAN.• Component Installer -- installs all ActiveX components used by the device for things such as video display andconfiguration.• Macromedia Flash Player -- necessary for displaying some components of the Web UI.The following are not necessary, but may be used for convenience:• Recording Software -- displaying and recording up to 16 channels simultaneously. Both the MPEG-4 and MJPEGdevices are supported.• Xvid -- a MPEG-4 codec. If no other MPEG-4 codecs (ie. DivX, 3ivX, ffdshow, etc.) are installed on your computer,the Component installer will install this for you.• QuickTime or VLC -- though not necessary, this can be used for viewing the MPEG-4 stream without a Webbrowser.Network configuration consists of modifying the network settings for the NDC in order to successfully connect to thedevice.12
Page 1 and 2: PiXORDMPEG-4 Network Dome CameraP-4
Page 3 and 4: 7.1 CALL OUT THE OSD SETUP MENU ...
Page 5 and 6: IntroductionWhat is Network Dome Ca
Page 7 and 8: P463T• Auto tracking movement.P46
Page 9 and 10: 1.2 Connection Jack and Cable Requi
Page 11: 1.3 DIP Switch SettingFan Power Swi
Page 15 and 16: - Outdoor Installation Structural D
Page 18 and 19: Note: After dome cover is attached,
Page 20 and 21: Note: After dome cover is attached,
Page 24: Note: When the NDC is installed ins
Page 27 and 28: 2.4 Network ConfigurationIP Install
Page 30 and 31: 5. A dialog box will pop up asking
Page 32 and 33: - Video Channel SelectionThe Video
Page 34 and 35: 3.2 Video and Audio RecordingBefore
Page 36 and 37: • Speed : Click on the UP/Down ar
Page 38 and 39: 4 Configuration of Web-Based User I
Page 40 and 41: • Frame Rate : The frame rate can
Page 42 and 43: - Image Adjustment• Contrast, Bri
Page 44 and 45: 4.4 PTZ SettingsSetting ID for NDCS
Page 46 and 47: - Preset Point SettingThere are 128
Page 48 and 49: - Setting Day / Night Mode (availab
Page 50 and 51: 4.6 Configuration of Network Settin
Page 52 and 53: Dynamic DNS Settings 1• Dynamic D
Page 54 and 55: 4.7 Configuration of System- System
Page 56 and 57: - User SettingsAdd UserTo add a use
Page 58 and 59: 4.8 Configuration of Event- General
Page 60 and 61: - Set Email and FTPE-mail SettingTh
Page 62 and 63:
10. Pedestal Adjustment11. Horizont
Page 64 and 65:
Back Light CompensationBack Light C
Page 66 and 67:
4. Click ESC button to exit menu, w
Page 68 and 69:
Manual Iris Speed Selection1. Click
Page 70 and 71:
Manual Focus Speeds SwitchAfter abo
Page 72 and 73:
6.2 Special FunctionsDisplay the Sp
Page 74 and 75:
2. Position the cursor beside VINTP
Page 76 and 77:
Expose Mode AE SettingPosition the
Page 79 and 80:
Auto Gain Control (AGC)AGC control
Page 81 and 82:
Expose Mode WDR SettingPosition the
Page 83 and 84:
Outdoor Mode (OUTDOOR)Position the
Page 85 and 86:
Special Function SettingSpecial Fun
Page 87 and 88:
Position the cursor beside Y NEGATI
Page 89 and 90:
7 Advanced Settings for P463TYou ca
Page 91 and 92:
7.2 Setup FunctionsInitial Setting
Page 93 and 94:
RET Time1. Click OSD(Enter) to reca
Page 95 and 96:
Back Light Compensation RegionThere
Page 97 and 98:
Iris Speed1. Click OSD(Enter) to re
Page 99 and 100:
ICR1. Click OSD(Enter) to recall OS
Page 101 and 102:
Aperture Correction AdjustmentThe 1
Page 103 and 104:
Multiple Dome means that more than
Page 105 and 106:
Dome Camera SelectionTo call out a
Page 107 and 108:
Horizontal 180 Instant FlipSome tim
Page 109 and 110:
6. Setting Preset Dwell TimeThe dwe
Page 111 and 112:
Activating Auto PanWhen the Auto Pa
Page 113 and 114:
Alarm OutputEach NDC has 1 alarm ou
Page 115 and 116:
114
Page 117 and 118:
116
Page 119 and 120:
Appendix A. Upgrading the SoftwareT
Page 121 and 122:
Reply from 192.168.0.200: bytes=32
Page 123 and 124:
4. Verify updated contentsAfter upl
Page 125 and 126:
Appendix D. Quick Reference Table f
Page 127:
Appendix E. Trouble ShootingNo Powe
show all

User's Manual - Pixord

Create successful ePaper yourself

Delete template?

Save as template?