User's Manual - Pixord

More documents

Recommendations

Info

Note: When the NDC is installed inside outdoor housing, please don’t attach dome cover. Violation may affectcamera performance.23
Page 1 and 2: PiXORDMPEG-4 Network Dome CameraP-4
Page 3 and 4: 7.1 CALL OUT THE OSD SETUP MENU ...
Page 5 and 6: IntroductionWhat is Network Dome Ca
Page 7 and 8: P463T• Auto tracking movement.P46
Page 9 and 10: 1.2 Connection Jack and Cable Requi
Page 11 and 12: 1.3 DIP Switch SettingFan Power Swi
Page 13 and 14: 2 Installation2.1 Installation Prev
Page 15 and 16: - Outdoor Installation Structural D
Page 18 and 19: Note: After dome cover is attached,
Page 20 and 21: Note: After dome cover is attached,
Page 26 and 27: 2.3 Software InstallationWith the e
Page 28: 4. From the list, select the device
Page 31 and 32: 3 Usage of Web-based User Interface
Page 33 and 34: To pan/tilt/zoom the external video
Page 35 and 36: 3.3 Video ConferenceClick [Video Co
Page 37 and 38: - Manually Set Up Additional Camera
Page 39 and 40: EventFunctionsGeneralDescriptionEna
Page 41 and 42: - Advanced A/V Settings• Interlac
Page 43 and 44: 4.3 Setting External Sources• Vid
Page 45 and 46: - Operating the Dome CameraTo contr
Page 47 and 48: 5. Set preset speed. The speed the
Page 49 and 50: 4.5 On Screen Display• On Screen
Page 51 and 52: Note: Before changing the listen po
Page 53 and 54: Dynamic DNS Settings 2• Dynamic D
Page 55 and 56: - Time Configuration• Time Mode
Page 57 and 58: - Firmware UpgradeUpgrading firmwar
Page 59 and 60: - Set Motion AreaThe “Motion Dete
Page 61 and 62: 5 Advanced Settings for P463You can
Page 63 and 64: Auto Gain Control SelectionThere ar
Page 65 and 66: 4. Click ESC button to exit menu, w
Page 67 and 68: Pedestal Adjustment16 levels of Ped
Page 69 and 70: Manual Zoom Speeds SwitchAfter abov
Page 71 and 72: 6 Advanced Settings for P463DWYou c
Page 73 and 74:
6. To set up a new privacy zone, po
Page 75 and 76:
6.3 Camera SettingsDisplay the Came
Page 77:
Mode changes as follows:• OFFDisa
Page 80 and 81:
3. Position the cursor beside BLC S
Page 82 and 83:
Push Mode (PUSH)Position the cursor
Page 84 and 85:
• Active 1 (Low Compensation)Acti
Page 86 and 87:
• MIRROR FunctionPosition the cur
Page 88 and 89:
Auto Iris Setting• Level SettingP
Page 90 and 91:
11. WB Cont12. Iris speed13. Zoom s
Page 92 and 93:
Another way to activate tracking mo
Page 94 and 95:
Sensitivity Up (Enhancement)Sensiti
Page 96 and 97:
White Balance Mode SelectionOne of
Page 98 and 99:
Focus Speed1. Click OSD(Enter) to r
Page 100 and 101:
Gamma8 levels of Gamma (Brightness)
Page 102 and 103:
8 Surveillance System Configuration
Page 104 and 105:
8.2 Initial Power Up InspectionAfte
Page 106 and 107:
Focus ControlThe focus function of
Page 108 and 109:
2. Selecting Preset pointPush key 1
Page 110 and 111:
Setting Preset GroupThe purpose of
Page 112 and 113:
Alarm ManagementThe 6 alarm inputs
Page 114 and 115:
9 Specifications113
Page 116 and 117:
115
Page 118 and 119:
117
Page 120 and 121:
Note: If FTP session quits immediat
Page 122 and 123:
Appendix B. Upgrade Custom Web Page
Page 124 and 125:
Appendix C. Emergency Factory Defau
Page 126 and 127:
PIH-801FunctionTo Tilt UpQuick Refe
show all

User's Manual - Pixord

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?