User's Manual - Pixord

Manual Focus Speeds SwitchAfter above steps were completed, the selected manual focus speed is stored in the NDC. To use the selected manualfocus speed under lens control, user has to click Lens Speed button before operation, otherwise manual focusingspeed will be "MEDIUM" as default. To switch back to "MEDIUM" manual focus speed simply click Lens Speed again.IR Cut SwitchOne of three different IR Cut modes can be selected. (Factory Default is AUTO)• AUTO : IR Cut filter auto switch according to Lux level. When light is over 5 Lux, IR Cut filter auto switch in andproduce color image. When light drops below 3 Lux, IR Cut filter auto switch out and produce monochrome image,under monochrome mode sensitivity is increased to 0.01 Lux and can be use with IR lighting.• ON : Always produce color images.• OFF : Always produce monochrome images.1. Click OSD(Enter) to recall OSD Setup Menu.2. Click the Up or Down button to select 21st item "IR Cut" on menu.3. Click Left or Right button to make selection: On -> Off -> Auto4. Click ESC button to exit menu, when finish or click Up or Down button to select next item.69