SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manualServo spindle spindle/C axle exchange:1. SYNTEC CNC can use the servo motor to be spindle ,at this time ,the control ofspindle can be exchanged by LADDER between C axle and spindle2. parameter 1791 set to 1 or 2 spindle is P type or V type servo motor ,at thistime ,CNC will auto change to servo spindle mode(allow spindle/C axle exchange)3. parameter 26,mecanical axle that C axle map to ,setup way is the same as X,Y,Zaxle ,ex:3 rd axle then mechanical axle set to 3 ,4 th axle set to 44. parameter 1621 set the mapping mechanical axle fixed to 6(because C axle logicdecide to 6)5. Ladder C63 OFF for the spindle mode ,turn or reverse is started by C64/C65 ,spindlerevolutions are controlled by process program S code,ex:M03 S1000;when ladder doM03 ,C64 ON6. Ladder C63 ON for off the spindle mode ,change spindle mode to C axlemode ,controller of spindle is controlled by C axle command in NC process programex:G01 C100. F200.;7. the time as below :C63C axles mode(M51)Spindle mode(M50)C axle mode(M51)Spindle stopsR36 less than 1C64/C65INVRUNM03/M04Spindle revolutions R36 less than 10Spindle loose8. Ladder design notes :1. design two M code to be the mode exchange(ex: M51:C axle mode ,M50:spindlemode)2. when controller on ,decide to spindle mode inside(M50)3. E_STOP ,Reset , M02 ,M30 back to spindle mode(M50)4. when Ladder do M51 ,make sure spindle is in stop status(R36 less than 1) ,canchange C63 to High only when stop5. when Ladder do M05 spindle stops ,when revolutions of spindle lower than 10r.p.m. (R36) ,please let contact of INV RUN OFF ,can loose the spindle (INVRUN in spindle mode M03,M04 ,and is ON in C axle mode)115