SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manualMitsubish A500 location card spindle location :1. power distribution :*. Connect spindle encoder signal to frequency converter ,and connect output offrequency converter encoder to CNC*. Except spindle turn and reverse signal(STF/STR/SD)need to distribution*. And ditribute location control(RL&RM short /SD : ON ) : start location function*. Finish locating : RUN/SE2. M19 location :*. M19 On ,RL/RM/SD start3. parameter adjust :*. Pr.180 set to 224. action :1. first let spindle OFF (M05 ,STF/STR OFF)2. after stop fully ,and send RL/RM/SD ON5. spindle location shift value(parameter 1751) : when set spindle location ,thedistance of location point of spindle head and index point ,setup steps : use handto turn spindle head to location position ,record the value of diagnosis screenparameter 28 (spindle absolute position value) ,record this value to parameter1751 ,when actual change the tool(M19) ,see the value of 28 in diagnosis screen ,isnear that value or not ,if not ,that is fixed offset value ,please adjust thisvalue ,this value must be adjusted when adjust spindle mechanism6. spindle location speed : must be matched with spindle location time ,inprinciple ,spindle location speed set about 300 –500 r.pm.7. spindle location time : the same as above ,in principle ,spindle location time is about500ms8. Mitsubishi frequency converter acceleration and deceleration time setup : 0.5s119