SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manual1. 5 axle card standards instruction:axle card selection and parameter setup description:SYNTEC CNC provide two axle card forms:(1) SERVO4 → fit to position circuit control frame。(2) SERVO6 → fit to position circuit and velocity control frame。(3) PMC4 → fit to velocity circuit control frame。The list contents is control mode and the kinds of mapping axle card and CNC controllerparameter setup。Control modeP Command(positioncircuit type)V Command(velocitycircuit type)Selection ofaxle cardSERVO4(note 1)CNCdescriptionparameter 9Setup valueCancel axle card wiring PIN7、1PIN8 the check function ofservo driver alarm signalAxle card wiring PIN7、PIN8 the2 check function of servo driveralarm signal is in NC(normalopen) contact modeAxle card wiring PIN7、PIN8 the3 check function of servo driveralarm signal is in NO(normalclose) contact modePMC4 4 V Command special axle cardSERVO6(note 2)5 V_P Command axle card selecte bychange jump on the cardNote 1: SERVO4 axle card counter to servo driver alarm provide 3 kinds ofcheck,mapping to 1、2 or 3 of CNC controller parameter 9,after CNCparameter 9 set,all CNC controller axle card active in the same wayof alarm check。Note 2: SERVO6 axle card counter to servo driver alarm provide 2 kinds ofcheck,mapping to 0 or 1 of CNC controller parameter 10,after CNCparameter 10 set,all CNC controller axle card active in the same wayof alarm check。(0 Normal Open ,1 Normal Close)22