SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manual• how to connect the wire at controller :name controller - driver name controller - driverA+ : Pin1 – CN1A.6 A- : Pin2 – CN1A.16B+ : Pin3 – CN1A.7 B- : Pin4 – CN1A .17C+ : Pin5 - CN1A5 C- : Pin6 - CN1A .15CW+ : Pin11 – CN1A.3 CW- : Pin12 - CN1A.13CCW+ : Pin13 - CN1A.2 CCW- : Pin14 - CN1A.12ALM+: Pin7 - CN1B.13&3 ALM-: Pin8 - CN1B.18SERVO ON : pin9 - CN1B .5SERVO_CLR : Pin10 - CN1A.8&CN1B.14OUT_COM : Pin15 - CN1A.10note :ALARM signal use the inside power(+24V) of driver ,so let driver 13 pin and 3 pin ofCN1B short ,SERVO_CLR and SERVO_RST this two signal should short in driver side ,when push downemergency stop(CNC not ready) ,five axles board SERVO_CLR and OUT_COM ,short willbe output ,this signal should do reset & clear to driver at the same time ,so CN1A 8 pin andCN1B 14 pin of driver should short• emergency stop : surface wire(normal close contact)depend on CE ,when there is emergent thing occur ,operator push emergency stopbutton ,must cut off the heavy electricity on surface line ,even though SERVO 5 in CNC notready status ,it will cut off SERVO ON ,servo will stop ,but still prevent some accident ,servounder control ,emergency stop button can force SERVO_OFF ,EMG contact of driver connect tothe normal close contact of interface E.STOP ,EMG(CN1B.15 ) can connect to CN1B.20 orCN1B.10• how to connect MPG :five axles card is all five axles controller board ,encoder interface is differential inputinterface ,therefore it may use MPG single ended situation ,need connect A+,B+ to +5V ,how toas below :name contorller - MPG name controller - MPGA+ : Pin1 – +5V A- : Pin2 – AB+ : Pin3 – +5V B- : Pin4 – B• standard cable :one 15 Pin D type ,aonther are two 3M joint ,there are 15cm between two joint ,emergency stop line left 100cm (blue line ,0.75mm**2) ,length : 1.5 m132