SYNTEC CNC Application manual - Winter Holztechnik

34SYNTEC CNC application manualNO Descriptions Range Unit Detail setting description418 Rigid tapping velocity [0,4000]gain419 Rigid tapping spindle [0,60000] msdeceleration time421~440 Axis cutting in-pos.window(BLU)[0,300000] BLU Performance of BLOCK ,to makesure the accuracy , but too smallset , will effect the speed of441~460 X axis rapid travel(G00) acc. time461~480 X axis max. rapidtravel feedrate481~500 Rapid travel in-pos.window501~520 Rapid travel F0feedrateprocess.[0,60000] ms Set acceleration and decelerationtime of G00 or JOG ,suggest : G01once above the acceleration anddeceleration[0,3600000] mm/mindeg/min0.1 in/minThe speed set of G00 , this acceptthe interface of RAPIDOVERRIDE setup (F0,25,50,100)[0,300000] BLU The range of G00 IN POSITIONCHECK[0,15000] mm/mindeg/min0.1 in/min521~540 JOG feedrate [0,3600000] mm/mindeg/min0.1 in/min541~560 Axis Accelerationand decelerationtime for cuttingfeedrate561~580 axis loss pulse checkwindowWhen G00 RAPID OVERRIDE setto F0 , the speed of machineSpeed set of each axis of JOG ,accept interface turned button ofOVERIRDE[0,60000] ms Setting the acceleration anddeceleration time of axis(G01/G02/G03/G31) ,system willuse the parameter with Pr621~640to calculatethe most Accelerationand deceleration.[50,300000] 0.001 mm Controller in the motor stopped,will check the feedback position ofmotor and if loss pulse over therange of parameter set,if it’s over,it will set the lost position alarm581~600 Axis velocity feed [0,200]forward percentage601~620 Axis Corner refer [6,3600000] mm/minSpeed621~640 Axis Maximum [0,3600000] mm/min Cutting maximum cutting Feedratecutting feedratedeg/min01. in/min641~660 Axis S-curve time [0,60000] msfor cutting701~720 Axis group setting [1,15] Setting the axis group of every axis.About the axis group controlinterface please refer toR520~R559 introduce.Bit 0 1st axis groupBit 1 2nd axis groupBit 2 3th axis group