SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manualHow SYNTEC CNC connect with EasyViewSYNTEC CNC controller can be PLC independent ,through RS232C matched with man machineinterface module ,such as EasyView , HiTech , Digital …ect. commercialized manmachine interface development environment ,Syntec CNC allowed with 三 菱 火 狐 貍 PLC(Mitsubishi FX series) fully consist man machine interfacecommunication convention ,the definition as below :INPUT : X --- I 0~127OUTPUT : Y --- O 0~127Supporting contact : M --- A 0~511Register : DL -- R 0~255*timer contact value : T --- Timer contact status*counter contact value : C --- Counter contact status*timer actual value : TV --- Timer presently value*counter actual value : CV --- Counter presently valueapplication point for attention as below :1. this fuction use man machine interface develop environment which is provided by遠 端 man machine interface panel ,to write the screen for client2. this controller provide the communication convention that consist withMitsubishi Fx,please set the output form to Mitsubishi FX communicationconvention when connect to CNC。3. X,Y,M,T,C,TV,CV are difined by user4. because R is 32-bit register,so one R map to two D,ex.R0 mapping DL0; R1 mappingDL2; R2 mapping DL4; R3 mapping DL6;R255 mapping DL510 ,detail definition of Ris according to SYNTEC CNC difinition ,dail definition consult SYNTEC CNCapplication manual5. reality I/O control ,control by SYNTEC CNC Ladder ,how to write Ladder ,pleaseconsult SYNTEC MLC manual .6. RS232 setup :Baud Rate:9600,Parity:Even,Data Bits:7,StopBits:1,Mode:Terminal,Code:ASCII。*for not provide in presently version。145