SYNTEC CNC Application manual - Winter Holztechnik

48SYNTEC CNC application manualITEMABBREV-IATIONDESCRIPTIONFUNCTIONSDRAY RUN modeC043 MLK Machine Lock All the travel command generate nomovement when this Flag is ON andunder the MACHINE LOCK mode.Only the coordinate display change.This is for the program checking.C044 OPS Optional Stop The program feed hold when it reachthe block with M01 and this flag ON.When the flag is off, the M01 isskipped.C045 ZLOCK Z Axis Lock The program stops the movementalong the Z axis when this flag is ON.This for checking the program.C046 COUPLE Axes couple state The system parameter NO 3825 is setas axes couple, then the axes couplestatus is decided by this bit. Whenthis flag is ON, the master and slaveaxes will be enable to couple. Thenthe slave move in proportion to themaster axis.C047 Inhibit Persist State Flush When this FLAG ON ,Inhibit systemPersist the state. If this flag statechange from off to on, system willpersist state .C050 XOTP Over Travel X+ The signal from X+ limit switchenables the flag ON, then thecontroller change to feed hold modeand can retract only in the oppositedirection by MPG or JOG.C051 XOTN Over Travel X- Same as aboveC052 YOTP Over Travel Y+ Same as aboveC053 YOTN Over Travel Y- Same as aboveC054 ZOTP Over Travel Z+ Same as aboveC055 ZOTN Over Travel Z- Same as aboveC056 COTP Over Travel C(6 th )+ Same as aboveC057 COTN Over Travel C(6 th )- Same as aboveC060 SO Spindle JOG Mode JOG the spindle as the value set insystem parameter NO. 1721 when thisbit is ON. This is used to control thespindle integrate with the gear changeor the bar feeder.C061 SOS Spindle Orientation Stop The spindle executes the spindleorientation function when this flag isON. This function is for the spindlewith encoder and the spindle rotatingspeed set by the system parameter NO.1741. The orientation angle is set atNO. 1751. Each time change themotor or the encoder, NO.1761 need