SYNTEC CNC Application manual - Winter Holztechnik

1721~173038SYNTEC CNC application manualNO Descriptions Range Unit Detail setting descriptionexist?(0:No;1:Yes)Spindle zero floatingspeed(RPM)1731~17401741~17501751~17601761~17701771~17801781~17901791~1800Minimum spindlespeed(RPM)Speed for spindleorientation stop(RPM)Spidnle S.O.S.reference offset[0,1000] RPM When main spindle inch movesstart , speed of main spindle ( lowspeed ) , the same as JOG andAUTO ,,it’s no limit from mainspindle lowest speed.[0,30000] RPM Minimum spindle speed inautomatic and manual[0,30000] RPM Main spindle location active,itslocation speed,not effect from limitof minimum spindle speed.[-3600000,+3600000]0.001 deg Main spindle location active,thebias angle of located potion,thisangle is opposite to same cyclesignal main spindle encoder。So thisparameter must adjust when changemotor、encoder or beltSpindle orientation [1,60000] ms Main spindle location active,stop dec. timedeceleration time of locationSpindle home [-360000, 0.001deg Main spindle position originreference offset +360000]opposite to bias of main spindleencoder guide signal 。 Let showposition of PLC R35 spindle。Min. speed for spindle [0,500] RPM Main spindle location active,orientation stopminimum of location speed,thisspeed is not effected by mainspindle speed*Spindle motor type [0,1] Select motor type,0 for frequencymotor,1 for serve motor[1,80000] RPMspeed1801 Maximum spindle1811 Spindle encodermount location1901~19201921~1940Spindle gear secondgear number at screw[1,999999999]sideSpindle gear secondgear number at motorsideSpindle gear third [1,gear number at screw 999999999]sideSpindle gear thirdgear number at motorside[0,1] (0:Spindle;1:Motor)~2000 Reserved for system ReservedGear rate of spindle second gearGear rate of spindle third gear