SYNTEC CNC Application manual - Winter Holztechnik

44SYNTEC CNC application manualNO Descriptions Range Unit Detail setting descriptionspindleG54 P#1040;// restoreworkpiece coordinate numberG90 G00 X#1411 Y#1412; //rapid move to programmed (x,y)G94 G01 Z#1413 F1000.; //cutting move to programmed (z) by1 m/minG#3 G#2 F#1; //restore G94/G95,G90/G91 mode,programmed federateM99;3861~3889 *2 nd ~4 st axisPlease refer Pr.3821coupling settingparameter3943 Second exchange [0,2] 0: ASCII;code type1: EIA;3944 COM1 control code(0:no;1:DC2;2:DC4;3:DC2&DC4)3945 COM1 end-of-blockoutputcode(0:EOB;1:CR&EOB)3946 COM1 DC3 controlcode parity (0:off ;1:on)3947 COM2 flow controlmode2: ISO;[0,3] 0: no DC control code;1: add DC2 to start of data;2: add DC4 to end of data;3: add DC2 to start of data and addDC4 to end of data;[0,1] 0: EOB;1:add CR before EOB[0,1] 0: no;1: yesthis parameter is meaningful whenthat is set to 2 in 39470: no;1: CTS/RTS hardware mode;2: Xon/Xoff software mode;3948 COM2 parity check 0: no;1: odd corresponding;2: even corresponding;3949 COM1 stop bit 1: 1 bit;2: 2 bit;~4000 Reserved forcoordinate system4001~50005001~60006001~8000Reserved for CNCdeveloper’s custommacroParametersReservedmanufacturer’scustom macroParametersforReserved for newparameter groupReservedReservedReservedReserved