SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manual3.2 S Bit (From CNC to PLC) S DESCRIPTIONSITEMABBREV-IATIONDESCRIPTIONFUNCTIONSS000 STL Cycle Start Light CNC enable this flag ON to indicatesthe BUSY status of the CNC.S001 SPL Feed Hold Light CNC enable this flag ON to indicatesthe FEEDHOLD status of the CNC.S002 BTP Block stop CNC enable this flag ON to indicatesthe BLOCK STOP status of the CNC.S003 FEINH Feedhold inhibit The flag ON to indicates forbidfeedhold.S004 Rigid Tapping When this FLAG is ON,the 1 st is onrigid tapping mode (G63)S006 XBUSY X Axis Busy The flag on to indicates the X axisbusy and can not accept newcommand. When the flag is OFF,then the X axis can accept the newcommand.S007 YBUSY Y Axis Busy Same as aboveS008 ZBUSY Z Axis Busy Same as aboveS009 CBUSY C(6 th ) Axis Busy Same as aboveS016 HMOKX X Axis Home Finish X Homing OK , This flag ON after Xaxis finished the HOME operation.The software travel limit is enableafter this flag is ON. Must checkthis before the cycle start in theLADDER program.S017 HMOKY Y Axis Home OK Same as aboveS018 HMOKZ Z Axis Home OK Same as aboveS019 HMOKC C(6 th ) Axis Home OK Same as aboveS029 MF M Code Read During CNC doing M CODE, enablethis flag ON to notice LADDER toexecute the M code. The value of Mcode is saved in R1. CNC enablethis flag till the LADDER sends the Cbit MST finished to disable. Thenexecute the next block after the flag isOFF.S030 DEN Distribution End MOTION G done a BLOCK send aDEN signal ,usually use in thesituation when G,M CODE actiontogether.56