SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manual6.analogy servo system wiring description :PMP2 card wiring :Axle card(PMP2) one card two axles ,line is all from PMP2 card CN1XY alxe card ,three lines out from CN1 ,one 8PINS to X axle driver(C06 6PIN,CO4 2PIN) ,one 8PINS to Y axle ,one 2 PINS to +5V,GND powerZA axle card ,four lines out from CN1 ,one 8PINS to Z axle ,one 2PINS to CMD+,CMD- tofrequency conversion ,8 PINS to ENCODER back the spindle ,2 PINS to power +5V,GNDMPG axle card ,take two line out ,4 pins to MPG ,2 PINS to power +5V,GNDIRT servo driver wiring :RST connect to power 220VU,V,W connect to motorCO6 is encoder signal contact ,six lines connect to PMP2 jointCO4 need signal as below :SPEED COMMAND+/SPEED COMMAND- (2,3) connect to PMP2 cardSERVO ON(14,15) connect to RELAY2 board O5SERVO ALARM (9,10) connect to RELAY2 board (I11..I14)128