SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manualSERVO4 card diagnose way :1. 1 st step : after opening the machine ,find Home ,at this time ,mechanical coordinate ,absoluteposition recoder(C) ,command absolute position recoder(P) ,should be clear to 0 at the sametime , P’,C’ of driver clear to 0 too2. 2 nd step : start to operate the machine normal ,or process in a long time ,when there is somethingwrong in position of machine ,do not shutdown ,please stop operating ,enter the followed checksteps3. 3 rd step : determine the signal from motor encoder to driver is normal or not ,find Home onceagain ,see if C’ of driver is 0 ,if not ,signal is interferenced form motor encoder to driver ,see ifP’ of driver is 0 ,if not ,it shows there is command be clear during the motion ,possible problem :SERVO ON be turned to OFF ,SERVO CLR ,SERVO RST ,E.STOP have action in signal4. 4 th step : make sure the signal from CNC to servo driver is not interferencedFind Home again ,C’ of driver is 0 ,see the diagnosis screen of controller ,C value of systemdata parameter 24,25,26 is 0 or not ,if not ,for the signal of driver and encoder is interferencedwhen it goes back to controller ,P of driver is 0 ,diagnosis screen data 40,41,42 P should be 0 ,ifnot ,CNC command to driver is interferenced .How to go into the screen :*. ESC back to the main screen*. Click “ ◥ “ ,enter sub-screen ,F1 : parameter setup ,F2 : diagnosis function*. Click F2 “diagnosis function “ enter sub-screen ,F1: PLC ,F2:system data*. Click F2 : “system data”enter diagnosis screen ,parameter 24,25,26 is absolute position recoderSYNTECPC BASEC'P'P-+CEP:command pulse waveC:execute pulse waveE:not execute pulse waveStatic E=0 , P should equal to CMove E=P-C , GAIN higher , E less126