SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manual4.5 rigid tapping machine diagnosis stepsvalid versionVersion 7.10 or newer versionVersion 7.11 or newer version,add parameter 418 to adjust acceleration circuit gainedVersion 7.12 or newer version,add parameter 1641 to set polarity of encoderVersion 7.15 or newer version,add parameter 419 to set spindle of rigid tappingdeceleration timeConnecting wire checkCheck the derection of spindle:system data 28 is the angle of spindle,unit 0.001degree。Please check when M03 spindle clockwise,system data 28 increase,M04decrease,if not,please spindle position encoder A+,A- signal,or let parameter 1641spindle encoder polarity set to 1(negative polarity)。Set the machine stepsRelated system data descriptionNO.13:spindle and Z axle along the Z direction following error max change range,unit BLU。NO.14:spindle and Z axle along the Z direction following error,unit BLU。NO.15:spindle and Z axle along rotate direction following error,unit degree。Related parameter descriptionNO.417:rigid tapping speed circuit gain,use to adjust the intensity of Z axle followspindle in the same speed step,Z axle fall behaind spindle more when this valueless,this value bigger,Z axle fall behind less,but when this value too big ,exceedor swing will occur。NO.418:rigid tapping acceleration circuit gain,use to adjust the intensity of Zaxle follow spindle in the acceleration step,Z axle fall behaind spindle more whenthis value less,this value bigger,Z axle fall behind less,but when this value toobig ,exceed or swing will occur。NO.419:rigid tapping spindle 1000RPM deceleration time,adjust the over cutting whentapping。Adjust steps1.write a tapping program,as below example,no material,only tapping go and back。2.adjust parameter 417 let the following error of go and back(system data 14/15)arethe same in symbol and proportions。3.adjust parameter 418 let the changed range in Z direction following error(system註 解 [Wilson1]:116