SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manualPMC4 axle card operation instruction:Controller can use 2 pieces of PMC4 axle card at once,each axle card cancontrol 4 form of V_Command servo system,so it can control 8 form V_Commandservo system at once。The way of axle card get number is divided by the three jump wire(sw0~sw2)on/off 。Each axle card setup and servo axle number:1. axle card Port Number and parameter setup number contrast table:Second axle cardFirst axle cardPort CNC parameter number Port CNC parameter numberP4 9 th servo axle/MPG P4 4 th servo axle/MPGP3 8 th servo axle P3 3 rd servo axleP2 7 th servo axle P2 2 nd servo axleP1 6 th servo axle P1 1 st servo axle2. each axle card mapping I/O base address and jump wire rule:Axle cardnumber1 stMapping axlenumber1~4I/OBaseaddress0x2C0(704)BASE ADDRESSSW0 SW1 SW2Short Open Open2 nd5~80x300(768)Open Short Short26