SYNTEC CNC Application manual - Winter Holztechnik

SYNTEC CNC application manualNO Descriptions Range Unit Detail setting description361~380 Element of position [1,999999999] Element of position command gaincommand gain381~400 Servo driver control [0,2] 0: CW/CCW Position control modemode1: Voltage control mode401 Acceleration anddeceleration time forcutting feedrate402 S-curve time forcutting404 Post-AccelerationandPost-decelerationtime for cutting405 Maximum cuttingfeedrate2: A/B Phase Position control mode[0,60000] ms Acceleration and deceleration timefor G01, G02, G03, G33. The largerthe value, the smoother themovement is. But the accuracy willno reduced. The suggested valuefor CNC is 100.[0,60000] ms Version before 10.35 suggestsetting is 20Version sfter 10.35 suggest settingis 150[0,60000] ms This parameter is used to smootherthe movement, But the accuracywill reduced. The suggestedvalue for CNC is 15-25.[0,3600000] mm/mindeg/min0.1 in/min406 Corner refer Speed [6,3600000] mm/min408 5mm Radius ARC [6,3600000] mm/minthe most cuttingfeedrateSet for the max cutting speed at(G01, /G02/G03/G31/G33)409 Thread cutting [0,60000] ms Acceleration and deceleration timeacceleration timeduring helical cutting G33410 MPG Movement [10,60000] ms Setting MPG Movement accelerationacceleration timetime(default Value 200)411 Rapid Travel(G00)type413 Reserve localcoordinate after reset414 Reserve WorkpieceCoordinate Systemafter reset415 *Res. cur. tool length.After reset/off(0:No;1:Yes)417 Rigid tapping [0,4000]acceleration/deceleration gain[0,1] G00 transverse type0:Linear interpolation1:All axes move in maximum speedindependently.[0,1] Reset the work coordinate set byG92 or G52 after reset[0,2] 0:After Reset reserve to default(G54)1:After Reset no reserve to default(G54)2:After Reset or Turn-OFF noreserve to default (G54)[0,1] 0: for NO1: for YES33