HX2 Reference Guide - Delfi

Continuous Scan ModeContinuous Scan ModeStart | Settings | Control Panel | Scanner | Barcode TabEnabling Continuous Scan Mode will ensure the laser is always on and decoding.Caution: Laser beam is emitted continuously. Do not stare into the laser beam.Set the Timeout between same symbol to a value sufficient to prevent the beeper from continuously beeping when a symbol isleft in the scanner’s field of view.When the barcode decoder is in continuous mode the scan button functions as an On/Off switch.The ring decoder red LED will always be off in continuous mode.The audio beeps and green LED work the same as they do for normal scan mode.If scan mode, power mode, or timeout between same symbol parameters are changed using external configuration barcodes inthe Ring Scanner Programming Guide, the HX2 operating system automatically restores the parameters to their programmedsettings upon a warm or cold boot and/or any change made in the control panel.Toggling between continuous and normal scan modes is in effect immediately upon pressing the OK button in this controlpanel, a warm boot is not required or necessary.E-EQ-HX2RG-M [ 143 ] HX2 Reference Guide