HX2 Reference Guide - Delfi

AppLock Error MessagesMessage Explanation and/or corrective action LevelRegistry read failure atreenter user modeRegistry read failure atreenter user modeRegistry read failureReset system work areafailureThe registry has to be read when entering user mode is the AppName is missing. Thisuser mode entry is attempted at boot and after a hotkey switch when the administrator hasclosed the application being locked or has changed the application name or commandline.The registry has to be read when switching into user mode. This is because theadministrator can change the settings during administration mode. The read of theregistry failed which means the Administration key was not found or the AppName valuewas missing or empty.The registry read failed. The registry information read when this message is logged is theapplication information. It the Administration key cannot be opened or if the AppNamevalue is missing or empty, this error is logged. The other application information is notrequired. If the AppName value is not available, AppLock cannot switch into user mode.The system work area is adjusted when in user mode to cover the taskbar area. Thesystem work area has to be adjusted to exclude the taskbar area in administration mode.AppLock was unable to adjust this area.LOG_ERRORLOG_ERRORLOG_ERRORLOG_ERRORShift pressed The Shift key has been pressed and trapped by the HotKey processing. LOG_EXShift Processing the hotkey and backdoor entry LOG_EXShow taskbarSwitching to adminbackdoorSwitching to adminhotkeypressSwitching to adminkbdhook.dllnot foundSwitching to adminkeyboardhookinitialization failureSwitching to adminregistryread failureSwitching toTaskbarScreenModeSwitching to user modeSwitching to user-hotkeypressTaskbar hook failureThe taskbar is now being made visible and enabled.The system is currently in user mode and is now switching to admin mode. The switchoccurred because of the backdoor key presses were entered by the administrator.The system is currently in user mode and is now switching to admin mode. The switchoccurred because of a hotkey press by the administrator.The keyboard hook load failed, so AppLock switches to admin mode. If a password isspecified, the password prompt is displayed and remains until a valid password isentered.If the keyboard hook initialization fails, AppLock switches to admin mode. If a password isspecified, the password prompt is displayed and remains until a valid password isentered.See the explanation of the “Registry read failure” above. AppLock is switching into Adminmode. If a password has been configured, the prompt will be displayed and will not bedismissed until a valid password is entered.In administration mode, the taskbar is visible and enabled.The registry was successfully read and AppLock is starting the process to switch to usermode.The system is currently in admin mode and is now switching to user mode. The switchoccurred because of a hotkey press by the administrator.AppLock is unable to control the taskbar to prevent the locked application from reenablingit.LOG_PROCESSINGLOG_PROCESSINGLOG_PROCESSINGLOG_PROCESSINGLOG_PROCESSINGLOG_PROCESSINGLOG_EXLOG_PROCESSINGLOG_PROCESSINGLOG_ERRORTaskbar hook OK AppLock successfully installed control of the taskbar. LOG_EXTimeout looking for appwindowToUser after admin, notat bootAfter the application is launched, AppLock must wait until the application has initializeditself before proceeding. The application did not start successfully and AppLock has timedout.The user mode switch is attempted when the device boots and after the administratorpresses the hotkey. The mode switch is being attempted after a hotkey press.LOG_ERRORLOG_EXE-EQ-HX2RG-M [ 271 ] HX2 Reference Guide