HX2 Reference Guide - Delfi

More documents

Recommendations

Info

Main TabMain TabStart | Settings | Control Panel | Scanner | Main tabParameterPortSend Key Messages(WEDGE)Enable ScannerSoundImager LEDIlluminationSingle ScanFunctionThe ports are disabled until the HX2 auto-detects a device tethered to the port. Port 1 defaults toBluetooth and Port 2 defaults to Ring when a Bluetooth enabled HX2 with ring scanner/imager ispowered OnDefault: Enabled.When Send Key Messages (WEDGE) is checked any data scan is converted to keystrokes andsent to the active window. When this checkbox is not checked, the application will need to use theset of LXE Scanner APIs to retrieve the data from the scanner driver. Note that this latter method issignificantly faster than using Wedge.Default: Enabled.Rejected barcodes generate a bad scan beep. In some cases, the receipt of data from the scannertriggers a good scan beep from an external scanner, and then the rejection of scanned barcode databy the processing causes a bad scan beep from the HX2 on the same data.The default setting is Internal illumination. The imager has a bank of three LEDs above the imageraperture that illuminate when External or Both radio buttons are enabled. The illumination turns offwhen the scan is complete.Options are Off (default), Auto and Man.Click here to view factory default settings for this panel.E-EQ-HX2RG-M [ 144 ] HX2 Reference Guide
COM1 TabCOM1 TabStart | Settings | Control Panel | Scanner | COM1This panel sets communication parameters for any device connected to the external port.Adjust the settings and click the OK button to save the changes. Any changes take effect immediately.This panel does not configure the connected device. Please refer to the documentation for the external connected or wirelessdevice for information on configuring the device.Note: COM default values are restored after a cold boot or operating system upgrade.Serial Port Pin 9COM1 does not support 5V switchable power on pin 9 for handheld serial tethered scanners. Ring scanners are tethered to theHX2. Handheld serial tethered scanners can be connected to the HX2 through the cradle serial port.E-EQ-HX2RG-M [ 145 ] HX2 Reference Guide
Page 1:
HX2 Reference GuideLXE | FLEX | Wea
Page 5 and 6:
Table of ContentsLAUNCH.EXE and Per
Page 7 and 8:
Table of ContentsLaunch Button 71Au
Page 9 and 10:
Table of ContentsStatus Popup 130Ow
Page 11 and 12:
Table of ContentsSummit Tray Icon 1
Page 13 and 14:
IntroductionThe LXE® HX2 is a smal
Page 15 and 16:
ComponentsComponentsFrontNote: Alph
Page 17 and 18:
BackBackWear on Left Side, Ring on
Page 19 and 20:
Ring Scanner and Ring ImagerRing Sc
Page 21 and 22:
Li-Ion BatteryLi-Ion BatteryMain ba
Page 23 and 24:
DisconnectDisconnect1. Push down on
Page 25 and 26:
RebootRebootWhen the Windows CE des
Page 27 and 28:
System MemorySystem MemoryThe 400MH
Page 29 and 30:
Audio SupportAudio SupportSpeakerTh
Page 31 and 32:
KeypadsKeypadsThere are three keypa
Page 33 and 34:
The Dual Alpha KeypadThe Dual Alpha
Page 35 and 36:
PowerPowerPower ModesPrimary Events
Page 37 and 38:
BatteriesBatteriesThe HX2 is design
Page 39 and 40:
Handling Batteries SafelyHandling B
Page 41 and 42:
General Windows CE Keyboard Shortcu
Page 43 and 44:
Folders Copied at StartupFolders Co
Page 45 and 46:
Software DevelopmentSoftware Develo
Page 47 and 48:
LAUNCH.EXE and Persistent Storage
Page 49 and 50:
DesktopDesktopFor general use instr
Page 51 and 52:
My Device FoldersMy Device FoldersF
Page 53 and 54:
Start FTP Server / Stop FTP ServerS
Page 55 and 56:
TranscriberTranscriberTo make chang
Page 57 and 58:
Advanced TabAdvanced TabTaskbar Pro
Page 59 and 60:
Taskbar IconsIconFunctionShift modi
Page 61 and 62:
Using ActiveSyncUsing ActiveSyncInt
Page 63 and 64:
Serial ConnectionIf a cradle is not
Page 65 and 66:
ConnectConnectConnect the modem cab
Page 67 and 68:
Configuring the HX2 with LXEConnect
Page 69 and 70:
Using LXEConnectUsing LXEConnect1.
Page 71 and 72:
Control PanelOptionPC ConnectionPow
Page 73 and 74:
Identifying Software VersionsIdenti
Page 75 and 76:
Administration - for AppLockAdminis
Page 77 and 78:
Administration ModeAdministration M
Page 79 and 80:
End-User Switching TechniqueEnd-Use
Page 81 and 82:
Application ConfigurationApplicatio
Page 83 and 84:
Launch ButtonOptionGlobalDelayInput
Page 85 and 86:
Auto Re-LaunchAuto Re-LaunchAuto Re
Page 87 and 88:
Allow CloseAllow CloseAllow Close C
Page 89 and 90:
Security PanelSecurity PanelSecurit
Page 91 and 92:
Status PanelStatus PanelUse the Sta
Page 93 and 94:
BatteryBatteryStart | Settings | Co
Page 95 and 96:
Bluetooth DevicesBluetooth taskbar
Page 97 and 98:
Clear ButtonAn icon with a white ba
Page 99 and 100:
Bluetooth Device PropertiesBluetoot
Page 101 and 102:
OptionsOptionPrompt if devices requ
Page 103 and 104:
OptionsOptionFunctionThis option is
Page 105 and 106: OPP SendOPP SendIf LXEZ Pairing OPP
Page 107 and 108: Using BluetoothUsing BluetoothStart
Page 109 and 110: Bluetooth IndicatorsBluetooth Indic
Page 111 and 112: HX2 without LabelHX2 without LabelI
Page 113 and 114: Using OPPUsing OPPPairing with an O
Page 115 and 116: CertificatesCertificatesStart | Set
Page 117 and 118: Device ManagementDevice ManagementS
Page 119 and 120: DisplayDisplayStart | Settings | Co
Page 121 and 122: BacklightBacklightThe backlight set
Page 123 and 124: Installed ProgramsInstalled Program
Page 125 and 126: Internet OptionsE-EQ-HX2RG-M [ 113
Page 127 and 128: KeyPadKeyPadStart | Settings | Cont
Page 129 and 130: KeyMap TabKeyMap TabAlpha Mode 3 Ta
Page 131 and 132: LaunchApp TabLaunchApp TabThe defau
Page 133 and 134: License ViewerLicense ViewerStart |
Page 135 and 136: MouseMouseStart | Settings | Contro
Page 137 and 138: Network CaptureNetwork CaptureStart
Page 139 and 140: NDISLogRun cmdPerforms the command
Page 141 and 142: Misc1. Use ActiveSync to copy GrabT
Page 143 and 144: OwnerOwnerStart | Settings | Contro
Page 145 and 146: PasswordPasswordStart | Settings |
Page 147 and 148: PowerPowerStart | Settings | Contro
Page 149 and 150: Regional and Language SettingsRegio
Page 151 and 152: Remove ProgramsRemove ProgramsStart
Page 153 and 154: Barcode Processing OverviewBarcode
Page 155: Continuous Scan ModeContinuous Scan
Page 159 and 160: ButtonsButtonsSymbology SettingsCtr
Page 161 and 162: Enable Code IDNotes• When Strip:
Page 163 and 164: ButtonsButtonsAddEntering data into
Page 165 and 166: Barcode Processing ExamplesBarcode
Page 167 and 168: ParametersReplacementThe edit contr
Page 169 and 170: ParametersParametersEnableThis chec
Page 171 and 172: Barcode Data Match ListBarcode Data
Page 173 and 174: Add Prefix/Suffix ControlAdd Prefix
Page 175 and 176: Length Based Barcode StrippingClick
Page 177 and 178: SystemSystemStart | Settings | Cont
Page 179 and 180: Copyrights TabCopyrights TabThis sc
Page 181 and 182: Good Scan and Bad Scan SoundsThe vo
Page 183 and 184: Briefly . . .Briefly . . .The Avala
Page 185 and 186: Preparing an LXE Device for Remote
Page 187 and 188: User InterfaceUser InterfaceThe Ena
Page 189 and 190: Avalanche Update using File | Setti
Page 191 and 192: ExecutionExecutionNote the dimmed o
Page 193 and 194: Startup/ShutdownStartup/ShutdownLXE
Page 195 and 196: TaskbarTaskbarLXE recommends using
Page 197 and 198: DisplayDisplayWindow Display Option
Page 199 and 200: AdaptersAdaptersNote: LXE recommend
Page 201 and 202: AdaptersNote: A reboot may be requi
Page 203 and 204: ExitExitThe Exit option is password
Page 205 and 206: Step 2: Scan BarcodesScan Barcode 1
Page 207 and 208:
Wireless Network Configuration for
Page 209 and 210:
Summit Tray IconSummit Tray IconThe
Page 211 and 212:
Main TabMain TabStart | Programs |
Page 213 and 214:
Admin LoginAdmin LoginTo login to A
Page 215 and 216:
ButtonsButtonsButtonCommitCredentia
Page 217 and 218:
Profile ParametersParameter Default
Page 219 and 220:
Diags TabDiags TabStart | Programs
Page 221 and 222:
Custom Parameter OptionFactory Defa
Page 223 and 224:
Global ParametersParameter Default
Page 225 and 226:
Global ParametersParameter Default
Page 227 and 228:
How to: Use Sign On ScreenSign-On S
Page 229 and 230:
Root CA CertificatesHow To: Use Win
Page 231 and 232:
WEPWEPTo connect using WEP, make su
Page 233 and 234:
LEAPTo use Stored Credentials, clic
Page 235 and 236:
PEAP/MSCHAPClick OK then click Comm
Page 237 and 238:
PEAP/GTCSee Windows Certificate Sto
Page 239 and 240:
WPA/LEAPTo use Stored Credentials,
Page 241 and 242:
EAP-FASTTo use Stored Credentials,
Page 243 and 244:
EAP-TLSOnce successfully authentica
Page 245 and 246:
CertificatesCertificatesNote: Pleas
Page 247 and 248:
Generating a Root CA CertificateCer
Page 249 and 250:
Generating a Root CA CertificateCli
Page 251 and 252:
Installing a Root CA CertificateBro
Page 253 and 254:
Generating a User CertificateClick
Page 255 and 256:
Generating a User CertificateAdvanc
Page 257 and 258:
Generating a User CertificateClick
Page 259 and 260:
Installing a User CertificateBrowsi
Page 261 and 262:
KeymapsAlpha Mode 3 TapDual AlphaTr
Page 263 and 264:
Alpha Mode 3 TapTo get this Key / F
Page 265 and 266:
Alpha Mode 3 Tap90To get this Key /
Page 267 and 268:
Dual AlphaTo get this Key / Functio
Page 269 and 270:
Dual AlphaTo get this Key / Functio
Page 271 and 272:
Triple TapTriple TapHints• Any ke
Page 273 and 274:
Triple TapTo get this Key / Functio
Page 275 and 276:
Triple TapTo get this Key / Functio
Page 277 and 278:
Environmental SpecificationsEnviron
Page 279 and 280:
AppLock Error MessagesMessage Expla
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Hat EncodingHat EncodingE-EQ-HX2RG-
Page 287 and 288:
Revision HistoryRevision HistoryRev
Page 289 and 290:
IndexAAbout 60Accessibility 62Activ
Page 291 and 292:
Index F - LEnabler Settings icon 17
Page 293 and 294:
Index R - SProfile Tab 202 screensa
show all

HX2 Reference Guide - Delfi

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?