HX2 Reference Guide - Delfi

Profile ParametersParameter DefaultRadioModeBGradio:BGRatesFullOrA radio:BGARatesFullExplanationSpecify 802.11a, 802.11b and/or 802.11g rates when communicating with the AP. The optionsdisplayed for this parameter depend on the type of radio (802.11b/g or 802.11a/b/g) installed in themobile device.Options:Default:B rates only (1, 2, 5.5 and 11 Mbps)BG Rates Full (All B and G rates)G rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)BG optimized or BG subset (1, 2, 5.5, 6, 11, 24, 36 and 54 Mbps)A rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps)ABG Rates Full (All A rates and all B and G rates with A rates preferred)BGA Rates Full (All B and G rates and all A rates with B and G rates preferred)Ad Hoc (when connecting to another client device instead of an AP)BG Rates Full (for 802.11b/g radios)BGA Rates Full (for 802.11a/b/g radio)Note: BG radio only – Previous SCU versions may have the default set as BG Rates Full.Depending on the SCU version, either BG Optimized or BG subset is the default.It is important the Radio Mode parameter correspond to the AP to which the device is to connect. For example, if thisparameter is set to G rates only, the HX2 may only connect to APs set for G rates and not those set for B and G rates.The options for the Radio Mode parameter should be set, based on the antenna configuration, as follows:Antenna ConfigurationA Main and BG MainA Main and A AuxBG Main and BG AuxRadio ModeABG Rates FullBGA Rates FullA Rates OnlyB Rates OnlyG Rates OnlyBG Rates FullBG SubsetContact your LXE representative if you have questions about the antenna(s) installed on your HX2.E-EQ-HX2RG-M [ 205 ] HX2 Reference Guide