HX2 Reference Guide - Delfi

Application ConfigurationApplication ConfigurationThe default Administrator Hotkey sequence is Shift+Ctrl+A.Administrator mode allows access to all features on the device. When the hotkey is pressed to switch into Administrator mode,a password prompt is displayed (if a password has been configured). A password must be entered within 30 seconds (andwithin three tries) or the password prompt is removed and the device remains in end-user mode with the focus returned to thelocked application. Without entry of a valid password, the switch into Administrator mode will not occur.Settings | Control Panel | Administration iconThe password prompt is displayed if a password has been configured. When the valid password is entered, the AdministrationControl panel is displayed. When a valid password is not entered within 30 seconds, the user is returned to the System ControlPanel.If a password has not been configured, the Administrator Control panel is displayed.Important: Before setting up multiple instances of the same application, make sure the targeted software applicationwill allow two instances to run at the same time.E-EQ-HX2RG-M [ 69 ] HX2 Reference Guide