HX2 Reference Guide - Delfi

Preparing an LXE Device for Remote ManagementPreparing an LXE Device for Remote ManagementTwo additional utilities are necessary for remote management.• The LXE Remote Management Utility (RMU) must be installed on all LXE mobile devices first – then you can controlmobile device reboot, storage RAM adjustment, real-time updates and Avalanche Enabler properties. If the RMU is notalready installed on the HX2, see Using Wavelink Avalanche to Upgrade System Baseline.If in doubt, verify RMU.CE.CAB exists in the \System folder. If the RMU.CE.CAB file is present when the Enabler isinstalled, the RMU is also installed.Important: If the OS package includes double-byte Asian fonts, the storage RAM property of the RMU must be higherthan the default value (40MB).If the amount of storage RAM is too low, the Enabler returns a “Mobile unit out of resources” error.To determine the minimum value required, inspect the RMU.StorageRAM>=nn parameter in the Criteria field for the OSpackage. Generally, this setting should be approximately 40 MB above the amount of RAM in use on the device for astandard OS and 50MB above the amount of RAM in use for an OS with Asian fonts.For example, if after installing all the software, the device shows 5MB in use, this setting should be about 45MB for astandard OS, 55 MB for an Asian font OS.• Use the LXE Wireless Configuration Application (WCA) when you want to remotely manage the Summit clientdevice. This utility is downloaded and installed in addition to the LXE Remote Management Utility. The WCA is includedwhen the Summit radio driver software is updated. The WCA is automatically installed when the radio driver is updated.If the LXE Remote Management Utility (RMU) is not present on the HX2, see Using Wavelink Avalanche to Upgrade SystemBaseline.E-EQ-HX2RG-M [ 173 ] HX2 Reference Guide