HX2 Reference Guide - Delfi

Wireless Zero Config Utility and the Summit RadioWireless Zero Config Utility and the Summit Radio• The WZC utility has an icon in the toolbar that looks like networked computers with a red X through them, indicating thatWireless Zero Config application is enabled but the connection is inactive at this time (the device is not connected to anetwork). The WZC icon may not be visible until control is passed to the WZC utility as described below.• You can use either the Wireless Zero Configuration Utility or the Summit Client Utility to connect to your network. LXErecommends using the Summit Client Utility to connect to your network. The Wireless Zero Configuration Utility cannotcontrol the complete set of security features of the radio.How To: Use the Wireless Zero Config Utility1. Select ThirdPartyConfig in the Active Profile drop down list as the active profile (see Main Tab).2. Warmboot the device.The Summit Client Utility passes control to Wireless Zero Config and the WZC Wireless Information control panel. Using theoptions in the Wireless Zero Config panels, setup radio and security settings. There may be a slight delay before the WirelessZero Config icon indicates the status of the connection.How to: Switch Control to SCU1. To switch back to SCU control, select any other profile in the SCU Active Config drop down list, except Third-PartyConfig.2. Warmboot the device.Radio control is passed to the SCU.E-EQ-HX2RG-M [ 198 ] HX2 Reference Guide