HX2 Reference Guide - Delfi

Global ParametersParameter Default FunctionWMMAuthServerTTLS InnerMethodPMKCachingOffType 1Auto-EAPStandardOff - Do not use Cisco IE and CCX version number.Cisco IE = Cisco Information Element.Use of Wi-Fi Multimedia extensions.Options are: On, OffNote: This parameter cannot be changed for some Summit radios.Specifies the type of authentication server.Options are: Type 1 (ACS server) and Type 2 (non-ACS server)Authentication method used within the secure tunnel created by EAP-TTLS.Options are: AUTO-EAP (Any available EAP method), MSCHAPV2, MSCHAP, PAP, CHAP, EAP-MSCHAPV2Type of Pairwise Master Key (PMK) caching to use when WPA2 is in use. PMK caching is designedto speed up roaming between APs by allowing the client and the AP to cache the results of 802.1Xauthentications, eliminating the need to communicate with the ACS server. Standard PMK is usedwhen there are no controllers. The reauthentication information is cached on the original AP. Theclient and the AP use the cached information to perform the four-way handshake to exchange keys.Opportunistic PMK (OPMK) is used when there are controllers. The reauthentication informationcached on the controllers. The client and the controller behind the AP use the cached information toperform the four-way handshake to exchange keys.If the selected PMK caching method is not supported by the network infrastructure, every roamrequires full 802.11X authentication, including interaction with the ACS server.If the active profile is using WPA2 CCKM, the global PMK Caching setting is ignored and the clientattempts to use CCKM.Options are: Standard, OPMKNote: This change does not take effect until after a Suspend/Resume cycle.WAPI Off Default is Off and dimmed (cannot be changed).TXDiversityBG: OnA: MainOnlyHow to handle antenna diversity when transmitting packets to the Access Point.Options are: Main only (use the main antenna only), Aux only (use the auxiliary antenna only), or On(use diversity or both antennas).The options for the TX Diversity parameter should be set, based on the antenna configuration, as follows:Antenna Configuration TX DiversityA Main and BG MainA Main and A AuxBG Main and BG AuxMain OnlyOnOnContact your LXE representative if you have questions about the antenna(s) installed on your HX2.Parameter Default FunctionRXDiversityBG: On-Starton MainA: Main OnlyHow to handle antenna diversity when receiving packets from the Access Point.Options are: Main Only (use the main antenna only), Aux Only (use the auxiliary antennaonly), On-start on Main (on startup, use the main antenna), or On-start on Aux (on startup, usethe auxiliary antenna).The options for the RX Diversity parameter should be set, based on the antenna configuration, as follows:E-EQ-HX2RG-M [ 211 ] HX2 Reference Guide