HX2 Reference Guide - Delfi

Barcode Processing ExamplesBarcode Processing ExamplesThe following table shows examples of stripping and prefix/suffix configurations. The examples assume that the scanner isconfigured to transmit an AIM identifier.SymbologyAll EAN-128(]C1) EAN-13(]E0) Intrlv 2 of 5(]IO) Code93Enable Enabled Enabled Enabled Enabled DisabledMin length 1 4 1 1Max length all all all 10Strip Code ID Enabled Enabled Disabled EnabledStrip Leading 3 0 3 3Strip Barcode Data *123 1* 456Strip Trailing 0 0 3 3Prefix aaa bbb ccc dddSuffix www xxx yyy zzzProvided that the wedge is configured with the above table, below are examples of scanned barcode data and results of thesemanipulations.Barcode Symbology Raw Scanner Data Resulting DataEAN-128 ]C11234567890123 bbb1234567890xxxEAN-128 ]C111234567890123 bbb11234567890xxxEAN-128 ]C1123 < rejected > (too short)EAN-13 ]E01234567890987 ccc]E04567890yyyEAN-13 ]E01231234567890987 ccc]E0234567890yyyEAN-13 ]E01234 ccc]E0yyyI2/5 ]I04444567890987654321 < rejected > (too long)I2/5 ]I04444567890123 ddd7890zzzI2/5 ]I0444 dddzzzI2/5 ]I022245622 ddd45zzzCode-93 ]G0123456 < rejected > (disabled)Code-93 ]G0444444 < rejected > (disabled)Code-39 ]A01234567890 aaa4567890wwwCode-39 full ASCII ]A41231234567890 aaa1234567890wwwCode-39 ]A4 < rejected > (too short)Note: Rejected barcodes generate a bad scan beep. In some cases, the receipt of data from the scanner triggers a goodscan beep (from the external scanner), and then the rejection of scanned barcode data by the processing causes a badscan beep on the same data.E-EQ-HX2RG-M [ 153 ] HX2 Reference Guide