HX2 Reference Guide - Delfi

Using LXEConnectUsing LXEConnect1. If an ActiveSync connection has not been established, connect the HX2 to the PC.2. Double-click the LXEConnect icon that was created on the PC desktop.3. LXEConnect launches.LXEConnect Notice4. Click the OK button to dismiss the About CERDisp dialog box on the desktop by clicking the OK button in the LXE-Connect window on the PC desktop.. The dialog box automatically times out and disappears after approximately 30 seconds.LXEConnect Desktop5. The HX2 can now be configured from the LXEConnect window. Input from the PC’s mouse and keyboard are recognizedas if they were attached to the HX2.6. When the remote session is completed, terminate the LXEConnect program by selecting File | Exit or clicking on the Xin the upper right hand corner to close the application, then disconnect the ActiveSync cable.Note: After using LXEConnect, the HX2 cannot go into Suspend mode until after a warmboot. If using PowerManagement on a HX2, always warmboot the HX2 when finished using LXEConnect.E-EQ-HX2RG-M [ 57 ] HX2 Reference Guide