HX2 Reference Guide - Delfi

Administration - for AppLockAdministration - for AppLockIntroductionLXE’s AppLock is designed to be run on LXE certified Windows based devices only. LXE loads the AppLock program as part ofthe LXE customer installation process.HX2 AppLock is setup by the Administrator by tapping Start | Settings | Control Panel | Administration.Configuration parameters are specified by the AppLock Administrator for the mobile device end-user. AppLock is passwordprotected by the Administrator.End-user mode locks the end-user into the configured application or applications. The end user can still reboot the mobiledevice and respond to dialog boxes. The administrator-specified applications are automatically launched in the specified orderand run in full screen mode when the device boots up.When the mobile device is reset to factory default values, for example after a cold reset, the Administrator may need toreconfigure the AppLock parameters.The assumption, in this chapter, is that the first user to power up a new mobile device is the system administrator.Note: AppLock Administrator Control panel file Launch option does not inter-relate with similarly-named optionscontained in other HX2 Control Panels.Note: A few applications do not follow normal procedures when closing. AppLock cannot prevent this type of applicationfrom closing, but is notified that the application has closed. For these applications, AppLock immediately restarts theapplication (see Auto Re-Launch) which causes the screen to flicker. If this type of application is being locked, theadministrator should close all other applications before switching to end-user mode to minimize the screen flicker.AppLock is updated periodically as new options become available. Contact your LXE representative for assistance, downloadsand update availability.E-EQ-HX2RG-M [ 63 ] HX2 Reference Guide