Line 6 Bass POD xt Live User Manual - MIDI Manuals

Creating & Storing Sounds • Inside the Edit MenuD.I. SettingsSpin the SELECT knob fully clockwise to see the edit page with D.I. settings:The two parameters on the left side of the page let you adjust the D.I. signal for mixingwith the Model signal. The first of these lets you mix some of the D.I. signal into theModel signal path, so the resulting blend is fed to Bass PODXT Live’s Model output.Press the Soft Button below DI>MDL and turn the knob down to the minimum settingto select OFF and no D.I. signal is added to the Model signal path. Or turn the knobclockwise to mix some D.I. in. This doesn’t affect the level of D.I. signal output by BassPODXT Live’s D.I. output.4 • 13The far right parameter on the page, DI DLY, lets you add a very small amount of delayto the D.I. signal relative to the Model signal. We give you the ability to delay the D.I.signal in .1 millisecond steps, which is so small a portion of time that you won’t hear itin terms of timing. The point of this delay is to throw the D.I. signal out of phase withthe Model signal, because combining the two signals with a shifted phase relationshipcan give you some great sounds that you can’t get from the normally phase-sync’dModel and D.I. signals output by Bass PODXT Live. This delay is applied to the D.I.signal so that you’ll hear it at Bass PODXT Live’s Model output, and the D.I. signal thatDI>MDL can feed into the Model signal path.