Register your product now - Radiometer Analytical

Edit the Other settings parameters. If you are using a VoltaLab 21 (PGP201):Check that "Display curve at end - Raw data" and "Display curve at end -Curve data" are selected.The Other settings are not significant when using a VoltaLab 21.. If you are using a VoltaLab 06, 10, 40, 50 or 80:Check that the "Anti-oscillation filter" is cleared. Select the frequency (50 Hz or60 Hz) of the power supply. This selection is used by VoltaMaster 4 to minimizethe background noise ratio on the measurements. Check that the otherparameters are as shown above.Anti oscillation filterIn potentiostatic mode and for low current measurement ranges (< 100 µA), thepotentiostat may start to oscillate with special electrochemical cells (cells with lowohmic drop and high double layer capacitance). This malfunction can be detectedby using an oscilloscope connected to the PGZ potentiostat "I OUT" or "E OUT"BNC sockets on the front panel. Activate the potentiostat anti oscillation filter inorder to eliminate these oscillations (a check mark is displayed when the filter isactivated).ImportantActivate the anti-oscillation filter only if the system starts to oscillate. In almost anycases, this filter should be disabled.For more information, press F1 to consult the Help file, keyword index:Other settings.20VoltaMaster 4 - Version 7.0xSection 2, Software installation