Register your product now - Radiometer Analytical

3.5 Set up your instrumentIf you selected the Routine setup mode while installing VoltaMaster 4, theInstrument settings are entered at the end of the software installation and cannotbe changedIf you want to change these parameters afterwards, you must switch to anotherVoltaMaster 4 setup mode. You do not have to re-install the software to change thesetup mode.Press F1 to consult the Help file, keyword index:How to select/change the VoltaMaster 4 setup modes?If you selected the Full or Supervisor/Operator setup modes while installingVoltaMaster 4:. Select the "Settings" menu then the "Instrument setup" command. If you donot have access to the "Instrument setup" command, it means that the monitorbar is activated. Disable the toolbar as follows: select the "Toolbar" menu thendeselect the "Monitor Bar" option.The Instrument setup for a VoltaLab 10 (PGZ100). Click the "Test" button. The instrument type (VoltaLab PGP201, PGZ100,PGZ301, PGZ402, PST006 or PST050) and version are displayed.. If it is not the case (communication failure (1) message), select "Potentiostat= VoltaLab PGP201 (or PGZ100, PGZ301, PGZ402, PST006 or PST050)",select the communication port (1 to 8) of the PC used for the connection to thepotentiostat for "Serial port" then click again the "Test" button.For more information, consult the Help file, keyword index:Instrument setup.VoltaLab 21/06/10/40/50/80 33Section 3, Chapter 5: Set up your instrument