G-Class Owner's Manual - Mercedes G-Class, G-Wagon, G500, G55 ...

Controls in detail
Operating system
Setting key dependence
You can use the SETTINGS KEY-DEPENDENT
function to determine whether the following
settings should be stored as key-dependent
settings:
Seat
Steering wheel
Mirrors
Select the CONVENIENCE submenu by
pressing the æ or ç button.
Press the j or k button repeatedly
until the SETTINGS KEY-DEPENDENT
message appears in the display.
The selection marker is on the current
setting.
156
P54.30-6222-31
Englisch (NL, RU): P54.30-6222en-31
Französisch: P54.30-7441-31
Italienisch: P54.30-7452-31
Spanisch: P54.30-6222sp-31
Switch key dependence ON or OFF by
pressing the æ or ç button.
Setting the parking position for the
exterior mirrors
Use the MIRROR SETTING WHEN PARKING
function to determine whether the exterior
mirror on the front-passenger side swings
down ( page 103) when you are parking
the vehicle (selector lever position R).
Nur fuer internen Gebrauch
The exterior mirror swings back to its original
position:
after you have disengaged reverse gear
(with a delay of approximately ten seconds)
when you reach a speed greater than
10 km/h, regardless of the gear engaged
if you press the button for the driver's
side exterior mirror immediately
( page 103)
Select the CONVENIENCE submenu by
pressing the æ or ç button.
Press the j or k button repeatedly
until the MIRROR SETTING WHEN
PARKING message appears in the display.
The selection marker is on the current
setting.