owner's manual (PDF) - Kawai

L2 Selects Play mode.
L4 Selects Sound mode.
P. 112
TRANSPOSE
• You can also activate the RIGHT2 Part to use as a layer (additional sound) for the melody. In
addition, if you know the melody to a Concert Magic song you can play along by activating the
SOLO Part. Remember, you must play the notes of the melody when the SOLO sound is active.
You can also select any new sound for the RIGHT2 and SOLO parts. Turn off all Parts except the
one you wish to change, and then select the new sound. Don’t forget to turn all necessary Parts
back on before you begin to play.
• You can save your new sound settings by pressing the SAVE button (F4). The Soft Reset function
will be required to return the sounds to their original settings (see page 144).
• You can transpose the song by pressing the TRANSPOSE buttons.
To enter the Chain Play mode of the Concert Magic:
1) Press the CONCERT MAGIC button. The song selection menu will be displayed.
2) Press the CHAIN PLAY button (F4). The Chain Play menu will be displayed.
3) Use the L and R buttons to highlight a setting, then turn the Dial to change that setting. You can
choose to play songs from any one category, or to play all 176 CM songs. You can also choose to use
each song’s preset sounds, or to play the songs using the Concert Grand piano sound only.
4) Press the PLAY button (F4) to start playing the songs.
5) To exit Concert Magic, press the CONCERT MAGIC button again.
L 1
R 1
L 2
R 2
R2 Selects the song category.
L 3
R 3
L 4
R 4
L 5
R 5
F 1 F 2 F 3 F 4 F 5 F 6 F 7
F4 Starts the chain play.
F6, F7 Returns to the song list.
Kawai Concert Performer Series Digital Piano