Compact / CANmotion /Motion Controller ... - Schneider Electric

Brake
settings
1 The r2 relay output is used for brake control.
2 To assign the r2 relay output :
Select FUn-
[APPLICATION
FUNCT.] and press
enter
Select bLC- [BRAKE
LOGIC CONTROL]
and press enter
Select bLC [BRAKE
ASSIGNMENT] and
press enter
Select r2 and press
enter.
Set the parameters to the
values shown here on the
right.
Note:
These parameters are for the
test machine only. They are
NOT VALID for every
machine.
After all parameters are set
return to the bLC with ESC.
Return to the bLC- with ESC.
Return to the FUn with ESC.
Performance CANmotion LMC058 Schneider Electric 127