(8.5x11) 6000 Manual Cover - Newport Corporation

Electrical Specifications:
DC Current Measurement (Low-Power, Semiconductor Photodiode CAL MODULE)
Signal Range: 1,2 0 1 2 3 4 5 6
Full-Scale Current: 4 2.51 nA 25.1 nA 251 nA 2.51 µA 25.1 µA 251 µA 2.50 mA
A/D Resolution: 126 fA 1.26 pA 12.6 pA 126 pA 1.26 nA 12.6 nA 126 nA
(20,000 Count Precision)
Display Noise Floor: ≤ 8 LSD ≤ 1 LSD ≤ 1 LSD ≤ 1 LSD ≤ 1 LSD ≤ 1 LSD ≤ 1 LSD
(Input Open, Filter Off)
Full-Scale Accuracy: 3 ± 0.1% 0.05% 0.05% 0.05% 0.05% 0.05% 0.05%
(Typical)
Full-Scale Accuracy: 3 ±0.48% .30% .30% .30% .30% .30% .30%
(Worst-Case)
1
Listed signal ranges specify meter capability. Available signal ranges are detector dependent.
2
Maximum measurable signal is detector dependent. See description of detector saturation message “SA”, page 80.
3
After 60 min warm-up, followed by execution of AUTOCAL command. See Section 2.4.4.
4
Full scale current may vary due to AUTOCAL compensation of DC offsets.
Analog Output
Full Scale Voltage: 0 - 2.5V into 50Ω
Accuracy: ± 2.5%
xii