(8.5x11) 6000 Manual Cover - Newport Corporation

LAMBDA_n
Lambda Select
Syntax: LAMBDA_n
where n is either A or B
Parameters:
The parameter is of type which rounds to an integer
with a range that depends on the detector being used. The units of
are nanometers and should correspond to the wavelength of the light
source being measured.
Function:
This command is used to specify the wavelength of light being measured.
This will insure that the proper responsivity calibration point will be used
when the 2832-C calculates measurement values.
Related Commands: ATTN_n, ATTN_n?, LAMBDA_n?, RESP_n?, USRCAL_n,
USRCAL_n?, USRRESP_n, USRRESP_n?
LAMBDA_n?
Lambda Query
Syntax: LAMBDA_n?
where n is either A or B
Parameters: None
Function:
This query returns the wavelength that corresponds to the responsivity
calibration point currently being used by the 2832-C in measurement calculation.
Returns:
is of type and represents an integer. The units of
are nanometers.
Related Commands: ATTN_n, ATTN_n?, LAMBDA_n, RESP_n?, USRCAL_n,
USRCAL_n?, USRRESP_n, USRRESP_n?
LLO
Local Lockout Enable
Syntax: LLO
Parameters:
The parameter is either 0 or 1. If is 0 then local lock-out is
disabled. If is 1 then local lock-out is enabled.
Function:
This command enables or disables the local lockout.
Returns: None
Related Commands: LLO?
61