AS-3640

Pos: 76.2 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Printer Driver & Cables to PC/7.X_Ü2_How to install and configure the printer driver_ONLY_619 @ 3\mod_1295280186142_912.doc @ 29403 @ 233
7 How to connect the printer to the PC
To connect the printer to a PC, use either the USB interface or the Ethernet interface of the
printer. To connect the printer to a network, use the Ethernet interface.
Independent from the interface (USB or Ethernet), it is necessary to install a printer driver
on the PC that will be used to send data to the printer.
Follow the installation procedures
Please follow the installation procedures described in this chapter.
Please stick to the order of installation steps (e.g connecting the
printer to the PC) as described in this chapter.
• Please see chapter 7.1 on how to install and configure the printer driver.
• Please see chapter 7.2 on how to use the USB interface
• Please see chapter 7.3 on how to use the Ethernet interface
The printer will work either with the USB interface or with the
Ethernet interface. The two interfaces cannot be used together at the
same time.
7.1 How to install the printer driver
7.1.1 Windows XP and Windows Vista
1. Insert the
driver CD-ROM
• Insert the Neopost CD-ROM in the CD drive of your PC.
2. Connect the
PC to the
printer
• Make sure that your printer is turned off.
• Connect the printer with the USB cable to your PC.
• Turn on the printer. Check if the printer shows OnlinUSB in the
bottom line of the main display.
If not press the Ok key to turn the printer online.
If the printer shows OnlinTCP in the bottom line of the main
display use the menu PRINTER CONFIG. > BOOT DEFAULTS >
COMMUNICATION to select the USB interface.
• Wait for the automatic detection of the new hardware.
User Manual Version 3.1 109