AS-3640

Pos: 75.69 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_1701_SOFT FONT ERROR @ 0\mod_1254908138045_912.doc @ 4705 @
Pos: 75.70 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_1702_SET PAP. TOLERANCE_non LOG Geräte @ 0\mod_1254908137717_912.doc @ 4701 @
Pos: 75.71 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Menüpunkte Drucker/Ü3/Ü4/Ü3_1703_ERROR LOW INK @ 0\mod_1254908138248_912.doc @ 4709 @
ERROR HANDLING
Select ERROR HANDLING in the PRINTER CONFIG. menu and hit the Ok
presented with the following choices:
key. You will be
SOFT FONT ERROR
This feature is used to set the printer response when it detects a PC font related error.
Option
cont. print
stop print
Default: stop print
Note
If a font error occurs, the machine will continue
printing. A warning message will be displayed.
If a font error occurs, the printer will stop and report
the failure.
SET PAP.TOLERANCE
Use this feature to set the tolerance of the measured paper length. The tolerance can be
varied in nine steps, from 8 mm up to 70 mm (0.31” up to 2.75”). If one sheet of paper
exceeds this tolerance level, the printer will stop and display an error message.
This value is important for detecting paper jams or double sheets inside the printer.
Therefore the default value of 8 mm should only be increased if the media being used truly
varies in length (e.g. magazines with inserts) or is made out of material that is difficult to
transport (e.g. thick, heavy, rough-textured).
When media of longer length is detected, the printer will stop and give the error PAPER JAM
OR WRONG PAPER WIDTH! CODE: 02
8mm, 13mm, 18mm, 23mm, 28mm, 38mm, 48mm, 58mm, 70mm
0.31”, 0.51”, 0,71“, 0.90”, 1.10”, 1.49”, 1.88”, 2.28”, 2.75”
Default: 8mm / 0.31 inch
76 User Manual Version 3.1